Search results for: 'Fluid analysis devices'

<p>The FluidMonitoring Software FluMoS Professional is a software program for reading in, displaying and editing data from HYDAC fluid sensors. It enables the simultaneous connection of 16 sensors. FluMoS Professional can be used in conjunction with sensors with HSI interface (CS 1000, FCU 1000, MCS 1000, AS 1000, FMM, HYDACLab®) and sensors without one (CS 2000, FCU 2000, FCU 8000).</p><ul><li><p>Parametrisation of the devices via sensor dialogue</p></li><li><p>Tabular and graphic online depiction of the measured values on the PC</p></li><li><p>Saving of log files to the hard drive</p></li><li><p>Depiction of log files from hard drive/floppy disk and backup as graphics file</p></li><li><p>Processing of saved log files, e.g. with Microsoft Excel</p></li><li><p>Update to new release through the Internet</p></li><li><p>Support by email</p></li><li><p>Very easy to use</p></li><li><p>Remote monitoring of the sensor measurement values</p></li><li><p>Condition-based maintenance</p></li></ul><p>FluMoS Light version available with reduced scope of functions.</p>

<p>HYDAC offers an extensive array of easy to use measuring systems. Whether it be solid particles or fluid contamination, for sporadic checking or as a permanent installation, under rough field conditions or in the laboratory.</p>The right tool for every application: <ul><li>Portable contamination measurement devices (for recording solid particle contamination and water saturation)</li><li>Stationary contamination measurement devices (for recording solid particle contamination and water saturation)</li><li>Laboratory equipment</li></ul>

The condition monitoring interface module CSI-B-2 is an additional segment of the HYDAC condition monitoring concept which connects the sensor level with the interpretation level.   It is a universally utilisable electronic device for the conversion of the HSI signal from HYDAC SMART sensors into a standardised PC signal. As a result, it becomes possible to read out the data and measured values of the connected SMART sensor directly using the HYDAC PC “CMWIN” software and the FluidMonitoring Software FluMoS. It remains possible to read out the long-term memory and to make settings and parametrisations on the connected sensor (the setting opportunities are sensor-dependent).   The HSI signal can be converted either into an RS 232 or an RS 485 signal. The CSI-B-2 can be connected to any given PC through the RS 232 port (and any possible additional commercially available RS 232 USB adapter). The RS 485 interface and appropriate additional coupling modules can also be used to connect to higher-level control and/or bus systems.     <ul><li>One input channel for HYDAC SMART sensors</li><li>Direct connection of the sensor via screw clamps</li><li>Display of the active interface via LED (RS 232 / RS 485)</li><li>Very compact design</li><li>Suitable for top-hat rail installation</li><li>Protection class IP 40</li></ul>